![]() To claim the full warranty a registration form may need to be completed - please check the paperwork enclosed with this product when purchased. Thereafter a repair or exchange as appropriate will be offered.Īfter the first year any warranty claims should be resolved with the manufacturer directly. We will exchange or refund within the first 30 days if a manufacturers fault is found with this product. Some manufacturers will offer a direct repair or replacement service (as applicable) which will often resolve your problem more quickly. Please note that cordless products will normally have a shorter warranty of just 1 Year for the battery and or charger supplied. In the unlikely event of a fault the item returned is subject to fair wear & tear and must not have been used beyond the scope of it's design. This product carries a full 3 year manufacturers warranty covering both faulty materials and faulty workmanship, it does not cover general wear and tear or damage, batteries, blades, bulbs and other consumables. The new range of 12 volt cordless drill, hammer drill, impact and screw drivers from Hilti give you. Warranty : 3 Year Manufacturer Warranty Compact, light, ergonomic and easy to use in tight spots.OR - Select your delivery address UK Region : Please ensure that you have selected the exact version of the product that you want above to get an accurate delivery charge. and is waterproof up to class 4–5 Test Report No.: A2210085110101C.You can calculate your postage charge for Einhell TE-CD 12/1 Li 12v Cordless Drill Driver before you checkout. * The water-repellent fabric test was conducted by Centre Testing International Co., Ltd. * Two extension rod designs are available and will be shipped randomly. ![]() The screwdriver bit test report was issued by the National Light Industry Tool Hardware Quality Supervision & Testing Station, Shanghai. *The battery test report was issued by Precise Testing & Certification (Guangdong) Co., Ltd. *The environmental reliability test report was issued by Intertek Shenzhen Ltd. *The EMC test report was issued by EMTEK (Shenzhen) Co., Ltd. *The whole unit ROHS test report was issued by EMTEK (Dongguan) Technology Co., Ltd. in Foshan Test Report No.: WTF21F3015226G. *The whole unit compliance test report was issued by Waltek Services Test Group Ltd. In M mode, the tail torque is adjusted to 30 and a 40mm-deep hole is drilled into a white pine board with a 7mm wood bit. *Wooden board drilling test method: With the device fully charged, the gearbox is adjusted to the high-speed setting (drilling mode). In M mode, the tail torque is adjusted to 30 and a hole is drilled into a 6mm-thick steel plate with a 6mm twist drill. *Steel plate drilling test method: With the device fully charged, the gearbox is adjusted to the high-speed setting (drilling mode). In manual "M" mode, the tail torque is adjusted to 10 and an M4 x 25mm self-tapping screw is screwed into the pine board until the battery runs out. * Screwing test method: With the device fully charged, the gearbox is adjusted to low speed (screwing mode). Speed test method: The fully charged device is run for 2 minutes at no load and the no-load speed is then tested with a speed tester. ![]() * No-load speed tolerance is approximately 10%. A torque tester is then used to test the locked-rotor torque at level 30. Torque test method: With the battery fully charged, the function selection button is pushed to enter screwing mode. ![]() * The maximum torque error is ±5Nm due to the measurement device used. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |